Avantone CR-14 >> Ribbon Microphone

Product Description

Our rugged CR-14 microphone body and inner assembly parts are precision machined of brass. Aesthetically, it features an elegant Cabernet Wine-Red finish, accented with polished nickel trim and a black grill. The CR-14 has a unique, “retro” body design.

The transformer coupled output will yield pleasing professional results comparable to much more expensive designs. Any studio can proudly offer the CR-14 as a guitar cabinet, room mic, drum overheads, vocal mic or utility room mic due to its versatility…It exudes class visually as well as sonically.

Manufactured using the finest materials yielding a very solid feel, superb structural integrity and rugged reliability. The versatile CR-14 mic is able to produce professional results with a warm, pleasing sonic character.

The included Custom Retro Shockmount is superb in allowing a precise positioning of the mic while inhibiting the transfer of unwanted vibrations up into the mic. This isolation allows for superior professional results.

The CR-14’s dual, low-mass ribbon element which enables a much better sensitivity rating than most single ribbon designs. This design lends to fast and accurate transient response, ultra-high 148 dB SPL capability, and overall stunning realism. It has a figure-8 audio directionality (pickup) pattern via front and rear, with extended sweet spots (as compared to Large Diaphragm condenser mics & single ribbon designs).

The CR-14 has very low residual noise, with no internal active electronics to overload or produce distortion. It also requires no power supply.

• Type: Ribbon Microphone
• Polar Pattern(s): Figure of 8
• Ribbon: Dual Ribbon / Pure Aluminum / 35mm x 5mm / 2 microns thick
• Frequency Response: 30Hz – 15kHz +/- 3dB
• Output Impedance: <=600 Ohms
• Recommended Load: Impedance 3000 Ohms
• Sensitivity: -52 dBv +/- 2dB Re. (0dB=1V/Pa)
• S/N Ratio: 70dB re 1Pa
• Noise Floor: < 17 dBA
• Maximum SPL: 145dB (0.5% THD @1000Hz)
• Output Connector: Male XLR 3 pin
• Power Requirement: None
• Included Accessories:
  • Padded Wooden Box
  • Shockmount
  • Metal road case
• Dimensions: 1.45″ (37mm) x 6.89″ (175mm)
• Weight (BV-1 Mic Only): 16 oz (496 grams)
• Finish: Polished Nickel trim / Glossy Butter-Cream Body